![]() ![]() In this FAQ we will be using destination device as a generic term for the device you are trying to connect to. This FAQ will help you to find out what is causing the problem in your specific situation. There are a number of possible causes for such a behavior. devices by NETGEAR or Linksys) are not capable of dealing with Host to Everywhere connections. Most devices designed for small office or home networks (e.g. Note that not alll VPN gateways can be configured for Host to Everywhere connections. ![]() In many cases, a suitable remote DNS setup is necessary for DNS resolution to continue to work.This traffic must be subject to Network Address Translation (NAT) in order for replies to reach the VPN gateway.The VPN gateway must route VPN traffic not destined for its local networks out on the Internet.For Internet access to work, several more things need to be configured on the VPN gateway: However, it is very likely that Internet access will not yet work. Once these are configured, it should already be possible to establish the VPN connection. The VPN gateway must accept an incoming VPN connection with a 0.0.0.0/0 (= everywhere) endpoint.The Network Topology must be set to “Host to Everywhere” in VPN Tracker.For this setup to work, it must be properly configured in VPN Tracker and on the VPN gateway: All non-local traffic will be sent through the VPN. Such a setup is called “Host to Everywhere” in VPN Tracker. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |